Pedaltrain Feet Lift Kit for Pedaltrain Models with 4 feet Lift Kit 01

Description

Pedaltrain Feet Modification Kit for Pedaltrain Models with 4 feet
This Pedaltrain Feet Modification Kit is the perfect solution to raising your Pedaltrain. It is a great solution for those of you with the Legacy PT-2 and PT-1 that would like to mount a side panel! Also, enables you to install a taller power supply under the board.
Here is what the kit includes:
(4) 1" Rubber Feet
(4) Screwdriver Installed Rivet Nuts
(4) 1/4-20 1" Phillips Pan Head Machine Screws
(1) Rivet Nut Installation Tool
(2) BTPA Left & Right Power Supply Mounting Brackets
(4) 8-18 1/2" Round Head Self-Drilling Screws
The kit not only will raise your pedalboard to properly fit panels on the sides of it, but it also will allow you to mount your power supply further back on the board. This is perfect for those of you running power on your interface panel. It will allow you to mount the power supply so that it is not flush to the rear of the board. It will ensure there is no cabling sticking out of the back of the board - allowing your board to fit nicely into its case.
*Disclaimer* using taller pedals on the top of your board, especially ontop of pedal risers, will cause the board to fit tighter into your hard case once the feet are installed.